top of page

Group

Public·16 members
Monney Willy
Monney Willy

Samsung Clone S10 Plus Flash File MT6580 8.1 Hang Logo Fix Firmware


Samsung Clone S10 Plus Flash File MT6580 8.1 Hang Logo Fix Firmware




If you have a Samsung Clone S10 Plus smartphone that is stuck on the boot logo or has a software problem, you may need to flash it with a new firmware. Flashing is the process of installing a new operating system on your device, which can fix various issues and improve its performance. However, flashing can also be risky and may cause data loss or damage your device if done incorrectly. Therefore, you should always backup your data and follow the instructions carefully before flashing your device.


In this article, we will show you how to flash your Samsung Clone S10 Plus smartphone with the MT6580 8.1 firmware, which can fix the hang logo problem and other software issues. This firmware is based on Android 8.1 Oreo and is compatible with the Mediatek MT6580 processor. You will need a computer, a USB cable, and some tools to flash your device. Here are the steps to follow:


Download File: https://t.co/Py2tfFOvcA



  • Download the Samsung Clone S10 Plus MT6580 8.1 firmware from [this link] and extract it on your computer.



  • Download and install the SP Flash Tool from [this link] on your computer. This is a software that allows you to flash Mediatek devices.



  • Launch the SP Flash Tool and click on the "Choose" button under the "Scatter-loading File" section. Browse to the folder where you extracted the firmware and select the "MT6580_Android_scatter.txt" file.



  • Click on the "Download" button at the top of the SP Flash Tool. This will load the firmware files into the tool.



  • Turn off your Samsung Clone S10 Plus smartphone and remove the battery if possible. Then connect it to your computer via USB cable while holding the volume down or volume up button. This will put your device into download mode.



  • The SP Flash Tool will detect your device and start flashing it automatically. You will see a green circle with a check mark when the flashing is completed.



  • Disconnect your device from your computer and insert the battery if you removed it. Then turn on your device and wait for it to boot up. It may take some time for the first boot, so be patient.



  • Congratulations! You have successfully flashed your Samsung Clone S10 Plus smartphone with the MT6580 8.1 firmware. You can now enjoy a smooth and stable performance on your device.




Note: This firmware is only for Samsung Clone S10 Plus devices with Mediatek MT6580 processor. Do not flash this firmware on any other device or model, as it may cause serious damage or brick your device. Also, make sure to backup your data before flashing, as flashing will erase all your data on your device. We are not responsible for any damage or data loss caused by flashing this firmware.


References:



  • [SAMSUNG CLONE S10 PLUS MT6580 VER 8.1 TUTORIAL & FLASH FILE FREE]



  • [Samsung S10 Plus MT6580 9.0 Clone Firmware Flash File Free]



  • [samsung_clone_s10_plus_flash_file_mt6580_8_1_hang_logo_fix_firmware_1ls ...]



  • [SP Flash Tool Download (All Versions) - Mediatek Flash Tool]




About

Welcome to the group! You can connect with other members, ge...
Group Page: Groups_SingleGroup
bottom of page